Hey Mopar-Muscle is back!! I remember you back in the day. I'm still around here, but definitely don't post as much as I used to.
Before thinking of replacing or rebuilding a starter replace the solenoid contacts with Larry B's heavy duty contacts. The contacts are the main...
It could be your overflow valve is bad. It is on the side of your VP44, at the fitting for the fuel return line. Cummins 3941156. Buy the...
It has always amazed me how wide of range Cummins allows on valve lash, pretty sloppy if you ask me. I have adjusted the valves on every one of...
Several years ago Joe Donnelly tested manual trans lube in a NV4500, comparing OEM with Amsoil, Royal Purple, etc. The OEM fluid performed the...
How is your truck's power? If it seems to be running normally then it's definitely something with your gauge (most likely the wiring or probe)....
Your crank position sensor is dying. Had it happen to mine. Cummins part number 5491995. Don't go with eBay stuff, get the actual Cummins part....
I switched to full synthetic at 155k miles and have 276k now. No leaks at all. It should not cause oil leaks for you.
Fantastic! I have been Googling for the same thing recently. I like this solution much better than trying to force-fit a 2-DIN touchscreen system...
Check your vacuum system to make sure it doesn't have any leaks, that can contribute to drips. My 24V came from the factory with the tappet cover...
10-4 on the K&N. That's the only air filter Cummins has mentioned specifically by name to never use.
Mayhem, I would replace the MAP sensor. They have certainly been known to go bad on these older trucks. Do the IAT while you're at it. I just...
BoeingDiesel when I had a similar issue with my truck it turned out one of my battery cables was bad. Lights shone brightly and everything worked...
If they physically fit they would probably be fine. But using caps from another engine means you'll have to align bore the mains to oversize. One...
Quite a project TimD! POR products work well for converting/neutralizing rust and recoating for protection. After that throw some Dynamat-type...
