I know its over used but I actually laughed out loud when I read that.
I'm sure I'll get hate-mail for the bling and Banks air horn, but oh well (the chrome was there when I got the truck and the air horn and red...
[ATTACH]
Thanks MGreer. I have been away for a little bit. I'll go into more detail later, but essentially I had crossed some injector wires. The truck...
Yeah, QA keeps giving me the stink eye.
I gotta watch out. Quality Assurance just showed up.[ATTACH]
Loosened the exhaust manifold. Cylinder #2 is spewing and smoking out of the exhaust.
I'll pull the exhaust manifold out a quarter inch, run the truck, and look for a smoking/sputtering cylinder. If I don't find any anomalies I'll...
I tried connecting with it (Solus) again today...didn't work. Hooked up my Bosch code reader...no problem. Pulled ECM pin connectors, cleaned...
I think you and Killer223 may be right about the injector but I need to figure out (1) if it's for sure a bad injector and (2) if it's a bad...
I also hooked the Solus up to my '07.5. No issues. Connected right up.
So I disconnected the wire connector to the CP3 pump while the truck was idling. The truck immediately lowered RPM and started knocking badly....
Was I supposed to disconnect the fuel rail electrical connector when I capped off each cylinder? Because I didn't do that.
3 times, twice while cold and once after I let it idle for 20 minutes and got it to operating temperature. All valves checked out perfect.