ABS sensor

Discussion in '3rd Generation Ram Forum (NO engine/transmission topics) Archive' started by mfurrh55, Sep 7, 2017.

Thread Status:
Not open for further replies.

  1. mfurrh55

    Can someone tell me , does the abs sensor go at the top of the hub when putting new hub on, when I pulled old ones off, rotors came with the hub, so I couldn't see behind and tell what position they were in , would appreciate fast info as I'm ready to install new hubs , Thanks in advance , Monte
     
    mfurrh55 , Sep 7, 2017
    #1

  2. BILTIT

    Yes on top, get a grease needle too and put some grease inside abs hole.
     
    BILTIT , Sep 7, 2017
    #2

  3. mfurrh55

    Thanks that is what I was thinking because of the routing of the line, but wanted to make sure, new hubs need to be greased?
     
    mfurrh55 , Sep 7, 2017
    #3

  4. BILTIT

    They dont need to be but will last a lot longer if you do.
     
    BILTIT , Sep 7, 2017
    #4
Loading...
Similar Threads - ABS sensor Forum Date
Any tricks to R and R for ABS sensor on rear pumpkin? 3rd Generation Ram Forum (NO engine/transmission topics) Archive Nov 16, 2011
3 things...ABS sensor, fan control, leaking steering box... 3rd Generation Ram Forum (NO engine/transmission topics) Archive Oct 6, 2009
Adding grease to front bearings under ABS sensor 3rd Generation Ram Forum (NO engine/transmission topics) Archive Dec 9, 2008
Thread Status:
Not open for further replies.

Share This Page